■Overview
The mobile equipment is evolving into smaller and more sophisticated equipment day by day.
This product has been developed as the multi-functional and small power management IC, in which the following functions are integrated into one chip: Power supply (Step-down DC/DC converter, 4-line LDO), Lithium-ion battery charge control, System reset, and Display white LED drive functions for the mobile equipment.
The type of package is QFN-32 whose size is 5mm by 5mm.
§ Features
1. | Integrates into one chip the functions for the power supply system. Adopts small package (5mm square QFN-32) so that the packaging footprint of the set products can be reduced. (Reduces the packaging footprint by 33% from that of the power supply system that is composed of discrete ICs) |
2. | Can cut cost by reducing the number of parts. |
§ Main specifications
|
|
|
Recommended operating voltage range |
2.7~5.5V |
|
External dimensions |
5.0ラ5.0ラ0.85(Unit: mm) |
|
Package |
QFN-32 (Pin pitch = 0.5mm) |
|
|
|
<< Electrical characteristics>>
Unless otherwise specified, the figures shown here are standard (or typical) values.
◊ Synchronous rectifying step-down DC-DC converter
|
|
|
Maximum output current |
500mA |
|
Output voltage |
1.2Vア2% |
|
Oscillation frequency |
1.0MHz |
|
|
|
◊ Regulator
|
|
|
Maximum output current |
150mA (in each line) |
|
Ripple rejection (f=1kHz) |
65dB (LDO1), 70dB (LDO2~4) |
|
Output voltage |
LDO1 3.3Vア2%
LDO2 2.8Vア2%
LDO3 1.8Vア2%
LDO4 3.0Vア2%
|
|
|
|
◊ Lithium-ion battery charge control
|
|
|
Constant voltage charge control voltage |
4.2Vア30mV |
|
Optimal charge sequence |
Detection of over discharge , Constant current charge (Pre-charge , Rapid charge) , Constant voltage charge , Detection of full charge , Re-charge |
|
Charge timer |
30 minutes, 4 hours |
|
Detection of battery temperature |
3C°/50° |
|
|
|
◊ System reset
◊ Driver for white LED
|
|
|
Maximum number of white LEDs that can be driven |
7 (Series) |
|
Over voltage protection function |
Included |
|
Brightness control function |
Controllable with the external PWM signal input |
|
Feedback voltage |
100mVア5mV |
|
|
|